[Nfd-dev] How to make face permanent exist after computers restart?
Ashlesh Gawande (agawande)
agawande at memphis.edu
Thu Nov 29 00:13:23 PST 2018
https://www.lists.cs.ucla.edu/pipermail/ndn-interest/2018-November/002315.html
Ashlesh
On 11/29/18 2:06 AM, "李峻辰" wrote:
> Hi,all
>
> Thank you for your reading!
> I am encountering some problems when using NFD and NLSR.
> I notice that NLSR will ask a set of face from NFD, then match the
> neighbor. But if there is no face the I need, so I need the face stay
> in nfd.
> I installed NFD on two computers respectively and each represents a
> node. The problems are:
>
> (1)I use the command "nfdc face create xxxx persistency permanent" to
> create face, but it seems something wrong with the face status, when I
> restart the machine, the face will disappear. I have to use the command
> again. So I wonder whether there is a way to keep the face maintain, or
> how to revise the file "nfd.conf" to automatically create the face when
> I start the nfd, how to code it?
>
> (2)I modified the NLSR configure files of the two nodes to make the two
> nodes connected to each other. But every time I start the nlsr, the node
> named "router1" always reports that "Router's Identity
> /ndn/edu/%C1.Router/router1 doesn't exit".
> Look forward to your reply. Thank you very much!
>
> Best regards,
> Junchen Li
>
> _______________________________________________
> Nfd-dev mailing list
> Nfd-dev at lists.cs.ucla.edu
> http://www.lists.cs.ucla.edu/mailman/listinfo/nfd-dev
>
More information about the Nfd-dev
mailing list