[Nfd-dev] nfd-start yield nothing after fresh installation
Thiago Teixeira
tteixeira at engin.umass.edu
Wed Jun 1 14:20:22 PDT 2016
Hi all,
I installed the NFD 0.4.1-21 binaries on two Ubuntu 14-64 bits and everything went well. The two machines are on the same subnet 10.10.1.0/24.
When I run $ nfd-start I get the following message: NFD is already running...
So I run $ nfdc register /ndn udp://10.10.1.1 and I should get the Successful... message, but I get nothing.
nfd-status yields nothing too.
I tried nfd-stop > nfd-start and nothing shows up.
I searched on the mailing list and couldn't find anything.
Do you have any suggestions or tests to do?
Thanks,
Thiago
PS: There's a typo in the building documentation instructions. It should be ./waf doxygen instead of doxgyen
http://named-data.net/doc/NFD/current/INSTALL.html#building-documentation
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://www.lists.cs.ucla.edu/pipermail/nfd-dev/attachments/20160601/7fd0af63/attachment.html>
More information about the Nfd-dev
mailing list