[ndnSIM] Abruptal interrumption of simulation
Spyridon (Spyros) Mastorakis
spiros.mastorakis at gmail.com
Fri Jun 26 07:16:03 PDT 2015
Hi Gustavo,
to assist you in the best possible way, I would like to know whether you use the visualizer or the command line logs. Moreover, when you said that you print the trace of a certain node, I guess you use our tracers, right?
Thank you.
--
Spyridon (Spyros) Mastorakis
Personal Website: http://cs.ucla.edu/~mastorakis/
Internet Research Laboratory
PhD Computer Science
UCLA
> On Jun 26, 2015, at 3:34 PM, Gustavo Gonzalez <gonzalezcga at gmail.com> wrote:
>
> Hello,
>
> I have been facing this problem. I have defined the wireless parameters to define an access point. When I check the interest and data messages in the wireless network everything is fine.
>
> When I include and connect to the Access Point a wired device through point to point link the data and interest messages keep going in the network but if I want to check the traffic that is flowing in each one of the nodes where the interest and data messages travel, then the simulation stops.
>
> I have also done only telling to the simulator to save the trace of a certain node in a file but then the simulation stops again.
>
> I suspect that due to a redifinition of the network characteristics of the node when I set the NetDeviceContainer in which I include the access point and the wired node is probably the cause of the problem but I am not sure.
>
> Please could you provide some hints to solve the issue. I have also run the debugger (gdb tool) and it exits normally without precising any error.
>
> Thanks for your support.
More information about the ndnSIM
mailing list