[ndnSIM] How to use nlsr as the routing protocol with consumer and producer in ndnSIM
anilj.mailing at gmail.com
Mon Feb 20 11:32:34 PST 2017
I did not say that -- NLSR will converge. I was suggesting it from the
point in your simulation where you start the producer application e.g. if
you start producer, before starting the NLSR application, it may not find
the routes. Hope this clarify your doubt.
On Sun, Feb 19, 2017 at 5:55 PM, Muhammad Hosain Abdollahi Sabet <
mhasabet at gmail.com> wrote:
> Why is that? I mean if I install and start a producer application on one
> of the nodes in ndn-simple-nlsr, why it isn't going to converge the routing
> tables? Isn't that why we expect from nlsr?
> On Sun, Feb 12, 2017 at 9:09 PM, Anil Jangam <anilj.mailing at gmail.com>
>> Hello Mahsa,
>> This scenario of application is not available yet nor tested. Below are
>> some some directions how it can be done.
>> As discussed, you will have to install the producer consumer apps on the
>> nodes along with NLSR and start the producer/consumer application as soon
>> as you detect that routing has converged. You can start them ahead of
>> routing convergence but it may not find the routes and traffic may not go
>> through. Please note that the default routing must disabled when NLSR is
>> On Feb 12, 2017 5:46 AM, "Mahsa Aghajani" <mahsa.aghajani at gmail.com>
>>> Dear ndnSIM users
>>> I need to run a topology consisting of a producer, a consumer
>>> and a few routers. I want to use the nlsr as the routing protocol
>>> in this simulation. I know I can use nlsrSIM which is ported by
>>> Anil Jangam into ndnSIM recently but I do not know how exactly I can do
>>> I appreciate if anyone help me doing this.
>>> Mahsa Aghajani
>>> M.Sc. Student
>>> Department of Computer Engineering
>>> Sharif University of Technology
>>> ndnSIM mailing list
>>> ndnSIM at lists.cs.ucla.edu
>> ndnSIM mailing list
>> ndnSIM at lists.cs.ucla.edu
-------------- next part --------------
An HTML attachment was scrubbed...
More information about the ndnSIM