<p dir="ltr">Hello Spyridon,</p>
<p dir="ltr">I use first the visualizer and the simulation ran without any problem but when I check each node the simulation stopped. Then I used the ASCII command and CS and L3 tracers to check what was travelling through the node but then the simulation crashed again. </p>
<p dir="ltr">Also, if a run the entire topology based on P2P links I don't have any problem. It is just when P2P and WiFi are present in the same simulation running ndn. </p>
<p dir="ltr">I appreciate the hints you could give me to solve it. </p>
<p dir="ltr">Regards. </p>
<div class="gmail_quote">Le 26 juin 2015 16:16, "Spyridon (Spyros) Mastorakis" <<a href="mailto:spiros.mastorakis@gmail.com">spiros.mastorakis@gmail.com</a>> a écrit :<br type="attribution"><blockquote class="gmail_quote" style="margin:0 0 0 .8ex;border-left:1px #ccc solid;padding-left:1ex">Hi Gustavo,<br>
<br>
to assist you in the best possible way, I would like to know whether you use the visualizer or the command line logs. Moreover, when you said that you print the trace of a certain node, I guess you use our tracers, right?<br>
<br>
Thank you.<br>
<br>
--<br>
Spyridon (Spyros) Mastorakis<br>
Personal Website: <a href="http://cs.ucla.edu/~mastorakis/" rel="noreferrer" target="_blank">http://cs.ucla.edu/~mastorakis/</a><br>
Internet Research Laboratory<br>
PhD Computer Science<br>
UCLA<br>
<br>
<br>
<br>
<br>
> On Jun 26, 2015, at 3:34 PM, Gustavo Gonzalez <<a href="mailto:gonzalezcga@gmail.com">gonzalezcga@gmail.com</a>> wrote:<br>
><br>
> Hello,<br>
><br>
> I have been facing this problem. I have defined the wireless parameters to define an access point. When I check the interest and data messages in the wireless network everything is fine.<br>
><br>
> When I include and connect to the Access Point a wired device through point to point link the data and interest messages keep going in the network but if I want to check the traffic that is flowing in each one of the nodes where the interest and data messages travel, then the simulation stops.<br>
><br>
> I have also done only telling to the simulator to save the trace of a certain node in a file but then the simulation stops again.<br>
><br>
> I suspect that due to a redifinition of the network characteristics of the node when I set the NetDeviceContainer in which I include the access point and the wired node  is probably the cause of the problem but I am not sure.<br>
><br>
> Please could you provide some hints to solve the issue. I have also run the debugger (gdb tool) and it exits normally without precising any error.<br>
><br>
> Thanks for your support.<br>
<br>
</blockquote></div>